Rockford Fosgate Prime R500-1 User Manual download pdf (Page 4)

345678

10 1011 1312

R500-1

1. Power LED – This LED illuminates when the unit is turned on.

2. Protect LED – This LED illuminates if a short circuit or to low of an impedance is detected at the

speaker connections.The amplifier will automatically shut down if this occurs.

3. RCA Input Jacks – The industry standard RCA jacks provide an easy connection for signal level input.

They are nickel-plated to resist the signal degradation caused by corrosion.

4. RCA Pass-Thru Jacks – This Pass-Thru provides a convenient source for daisy-chaining an additional

amplifier without running an extra set of RCA cables from the front of the vehicle to the rear amplifier

location.

5. Gain Control – The input gain control is preset to match the output of most source units.

6. Phase Switch – Allows you to select the output phase of the amplifier between 0° and 180°.

7. Variable Crossover (Low Pass Only) – Is a built-in 12dB/octave Butterworth filter with a

crossover point variable from 40Hz to 130Hz.

8. Punch Bass – This is an adjustable Bass level control centered at 45Hz @ 12dB/octave.

9. Remote Punch Level Control – When connected, the “Gain Control” is linked and allows you to

remotely control the output level of the amplifier from the dash or center console.

10. Power Te rminals – The power and ground are nickel-plated clamp wire connectors and will

accommodate 4 AWG #8 (up to 1/2”) spade or ring style connectors.

11. REM Terminal – The nickel-plated clamp wire connector and will accommodate 8 AWG #8 (up to 3/8”)

spade or ring style connectors.This terminal is used to remotely turn-on and turn-off the amplifier when

+12V DC is applied.

12. Fuses – These ATC fuses are easily accessible in case of failure.Always replace fuses with same type and

rating. See Specifications for fuse ratings.

13. Speaker Te rminals – The heavy duty, nickel-plated clamp wire connectors (

and -) will accommodate

8 AWG #8 (up to 3/8”) spade or ring style connectors. Two Positive (+) a

nd Negative (–) terminals

are provided for installation flexibility. Both terminals are wired in parallel internally. Only

one Positive (+) and one Negative (–) terminal is required for a speaker connection.

DESIGN FEATURES

1 2 3 4 5 6 7 8 9 ... 51 52

No comments

Rockford Fosgate Prime R500-1 User Manual Page 4