Rockford Fosgate IB-200 User Manual download pdf (Page 4)



Vehicle Installation

CAUTION: Due to the requirements of how the IBeam tactile transducer

needs to be mounted in a vehicle, we strongly

recommend it be installed by a

qualiﬁed Rockford Fosgate technician.

For best performance, the IBeam

should be mounted to the

underside frame of the seat.

If your seat does not allow for

proper mounting, the IBeam

can be mounted under the

center console.

Where ever you end up

mounting your IBeam, make

sure all surrounding items are mounted

ﬁrmly and tight. If not, these items will rattle when the IBeam is working.

Vehicle Connection

CAUTION: Before installation, disconnect the battery negative (-) terminal

to prevent damage to the unit, ﬁre and/or possible injury.

The IBeam can be powered by any 4 ohm stable ampliﬁer that provides a minimum of

100 Watts RMS @ 4 ohms. Ampliﬁers with 150 – 250 Watts @ 4 ohms offer the best

experience.

1. Pre-route 16/14 or 12AWG speaker wires from the IBeam unit to the ampliﬁer it will be

connected to.

CAUTION: Be sure to route wires were they will not be damaged due to sharp

edges or from the movement of the seat.

2. Connect the speaker wires to the IBeam and mark them to maintain proper signal polarity

when connecting to the ampliﬁer.

3. Follow the instructions provided with the ampliﬁer being used to connect it to the vehicle

system.

4. Connect the speaker wires from the IBeam to the output on the ampliﬁer. Be sure to main-

tain proper signal polarity for best performance.

5. For best performance set the ampliﬁer to low pass (LP) with a crossover setting of

100-300hz.

PUSH

Speaker connection from amplifier.

Multiple IBeam system.

To insert

wire

Be sure to mantain signal polarity.

1 2 3 4 5 6 7 8 9 ... 19 20

No comments

Rockford Fosgate IB-200 User Manual Page 4